One box will wrap both side of a bar. One box needed per bike.

One packet has two strips/two bar end caps and two shoddy bits of tape (use your own insulating tape!) - enough for both bars

ONe pack will do both sides of the bars. look on you tube for how to tape your bars as this was helpful in getting it working spot on.

One packet of this tape does both ends of the handlebar and contains the bar end plugs

You get two lenghts of tape, two bits of finishing tape and two Easton logo end caps, so will do a set of bars both ends.

There is 2 rolls one for each handle bar, there was plenty on each roll so I had to cut it to length, plus some short strips to put behind the hoods to ensure non of the bar is exposed.

Packet has two rolls of tape - one for each side of bar.
Plus the little 3 inch bits to cover the rear of the break levers and matching electrical tape and bar ends.

There are two lines of tape, to do two bars. You need to get it right though, as there isn't loads of extra tape if you like a tight fit and have wide bars!

The pack comes with 2 rolls, 2 pieces of tape and 2 bar-end plugs so should be enough for both sides of a drop bar (unless you have very wide bars or wrap it really closely overlapped)

Plenty for both sides. I had 1 and 1/2 inches too much (as they say)

It's not reflective.

Theres a logo on the end plug. But it is not reflektive.

No they are black

THe ends are shiny but they are not reflective

Nope - it's basically a transparent cap over the 'E' (Easton) logo on a black background.

No not reflective - just shiny!

No the end plug is not reflective

No, they have a non-reflective E logo.

It looks like there might be a small amount of reflective material in the design of the logo, but it really isn't very significant. Check out the photo...

No

The Easton tape is adhesive backed and then you seal it with the tape provided. I used some electrical tape to reinforce this because it did not feel quite secure enough and I could not have it unwinding whilst on the road.

yes a peel off strip to reveal a sticky back

Yes the Easton Cork Bar handle bar tape is adhesive backed and it's better quality adhesive than some other products I have used.

it has adhesive under pulloff tape,good hold

there is a thin adhesive strip in the middle, yes, although it's only really needed for placement until you use the finishing tape/plugs.

Yes, if you tuck the excess tape in the bar.

You tend to shove a bit of the tape inside your bars then ram the plugs in to get a tight fit that grips the tape, if you have more space to fill you wrap the end of the plug in the tape too

on my truvativ mtb-bar they fit perfect

No it is a royal blue

The blue is dark but maybe not quite Navy!